GASKET: 3MM Cascading 7.5 Center to Center DRAW for Master Tuning Table | MasterHarp

GASKET: 3MM Cascading 7.5 Center to Center DRAW  for Master Tuning Table

This is the cascading 7.5 center to center spaced gasket used to tune DRAW PLATES on the master table.

Lee Oskar, Special 20s and Tombos are a few of the Reed plates with multiple holes in the plates that will be better accommodated with this gasket. You will not have to tape the holes so much to seal against the gasket. You can also block off the back to do single draw plate tuning on the master table.

$43.20

Status message

  • 20% HOLIDAY DISCOUNT APPLIED!
  • Thank You!